Bottom plate replacements?

[cardinal of crunk]

I'm thinking it would be a good idea to replace the bottom plate on a few incoming BJF's so that I can put velcro on them and not have to worry about tearing up the nice paint job. I have a Phase 90... would that fit? If not, can anyone recommend where to look for one, or give me the model number of the enclosure/enclosure of the same size?

[Eskimo_Joe]

bump, anybody have the scoop on this?

[NewarkWilder]

I picked up a couple of these for this very appilication--

http://cgi.ebay.com/NEW-SENSOR-1290NS-D ... 240%3A1318




it'd be nice to find super cheap bottom-only plates but these boxes are the right size and come with the bottom plate w/ just the right screws and holes and everything. you might find a better option out there but this is what I did. Cool seller, he's got some other painted boxes too.

[Eskimo_Joe]

Thanks for the tip!

[bjfanimal]

Hi.

My first post here. I think Björn use the ELFA K430 box.
http://www.elfa.se/ - search for ELFA K430 - there you have it.

Hope this helps