>>> Sparkle Face Research Project <<<

Open discussion about all things BJFE

Moderator: Moderators

>>> Sparkle Face Research Project <<<

Postby Donner » Fri Sep 30, 2016 5:36 pm

Yup. A new Research Project !

Bjorn has something new hes been working on and after talking about it, it would be great to have some direct input from a group of players all at once.

So if there is interest, we will do a research round right here like the good old days ...

This one is in search of a perfected Fuzz Face with Bjorns magic touch and parts selection .... more gain available, much less noise, led and typical polarity etc......

As it may take awhile for enough folks to wander back in, this is a few weeks away ......

So if you are interested in participating or just watching it unfold - post here and you will get notifications as things develop ..... 8)


If you dont know what Im talking about - we used to do this here for new BJFe models like the Sparkling Yellow and Model H ....

There are a limited number of units and they will all be sold sent out at the same time, and reviewed at the same time ........
User avatar
Donner
Site Admin
 
Posts: 3547
Joined: Mon Feb 26, 2007 11:52 pm
Location: St.Louis
Guitars:: Strats, Teles, LPSpecial, Silvertone, #1 is a Gretschified Flying V
amps: custom plexitweed KT66>2x12 Greenbacks, Deluxe and Princeton Reverbs
pedals: 0

Re: >>> Sparkle Face Research Project <<<

Postby melodichaotic » Fri Sep 30, 2016 11:26 pm

I check in every so often and just happened to see this...interested...if someone
Is going to do the FF circuit right, it's Bjorn...sounds like fun
melodichaotic
 
Posts: 548
Joined: Wed May 13, 2009 11:38 pm

Re: >>> Sparkle Face Research Project <<<

Postby zhivago » Sat Oct 01, 2016 3:17 am

I'd be interested to get involved in this.

I have been looking for the perfect fuzz for many years :)
BJFE: MH4K, HBOD, PGOD
User avatar
zhivago
 
Posts: 198
Joined: Tue Jun 03, 2008 8:43 am
Location: London, UK
Guitars:: 1956 Gibson Les Paul Custom
1961 Fender Jazzmaster
1952 Gibson J50
amps: 1956 Fender Princeton
2013 Matchless Lightning
Ceriatone Tweed Deluxe
1979 Marshall 4x12
ZVex Nano Amp
pedals: 10

Re: >>> Sparkle Face Research Project <<<

Postby analoghog » Sat Oct 01, 2016 7:17 am

I'm in !

My favorite Fuzz !
User avatar
analoghog
 
Posts: 293
Joined: Sat Jun 16, 2007 11:13 pm

Re: >>> Sparkle Face Research Project <<<

Postby ak47 » Sun Oct 02, 2016 2:51 am

I am so totally in on this Donner! I think this will be a great opportunity for some more momentum here.. oh, and I reeeaaally dig fuzzzzz!! :mrgreen: :music :pedallove
"The music business is a cruel and shallow money trench, a long plastic hallway where thieves and pimps run free, and good men die like dogs. There's also a negative side." - Hunter S. Thompson
User avatar
ak47
 
Posts: 421
Joined: Tue Dec 20, 2011 5:52 pm
Location: Sweden
pedals: 0

Re: >>> Sparkle Face Research Project <<<

Postby Vinkie » Sun Oct 02, 2016 6:42 am

I would also be very interested in Bjorns take on this classic design (that surely could do with an upgrade or two.)
User avatar
Vinkie
 
Posts: 3
Joined: Mon Sep 19, 2016 5:06 pm
Location: Utrecht, The Netherlands
Guitars:: '60 Fender Jazzmaster, '63 Fender Jazzmaster, '63 Fender Jaguar, '07 Rickenbacker 381/12V69 MapleGlo
amps: 1957 Gibson GA-40, 1965 Fender Deluxe Amp, 1978 Fender VibroChamp
pedals: 6

Re: >>> Sparkle Face Research Project <<<

Postby BJF » Sun Oct 02, 2016 7:36 pm

:boohoo Hi

Thank you for taking interest in the Sparkle Face project. Funny the last time I made a Fuzz Face circuit with germanium transistors was back in 1982 when a friend obsessed with Jimi Hendrix asked me to build him one, which I did.
Anyway earlier this year I found in a drawer a left over pcb from 1982 but one that housed BC108C’s. I felt compelled to get that working and made a pedal that went to a friend. Anyway it got me thinking that I have some fine germanium transistors
of the last generation when the germanium transistor finally rivaled silicon but alas became too expensive for commercial use and were mostly used in early computors and snuck into some power amps but as years went by they were replaced by all silicon.
The point is there’s no magic just parts and the way you use them. So these transistors- and really a fuzz face circuit totally relies on its transistors- that I am using for this have low leakage in fact not bad at all compared to silicon and medium gain, no pop corn noise
and generally fairly good noise levels comparable to silicon and low temperature drift also comparable to silicon, but they are germanium transistors and have as such a lower Base to Emitter impedance referred to as hie in the four h parameters, and fairly low transit frequency.
For use in a fuzz pedal or actually for use in amplifier in general, these two parameters give rise to lower order distortion than silicon and the transfer function that is not as sharp. Now it’s a fuzz and yes you can get near perfect square wave with an emphasis on ’near’.


For musical use and as fuzz I have focused on getting the traditional sort of warm fuzz sound meaning one that does not make compensation for the various strength of the strings plucked- of course that makes the wound string thick of buzz while the unwound strings can
get a more violin or organ type of tone.
Because of this certain playing styles are suggested and so I have kept to this and not made sound more modern other than ever so slightly restricted broadband noise.


Sparkle Face has three controls

Volume and for this I have used a value similar to a guitar pot at 500K Log and this so that the traditional filter effect with an orange spiral cable can be achieved.

Saturation and this is a control that alters what the guitar sees as in either a low impedance current input or a slightly higher voltage input- what this means for the guitarist and the sound is that some of the more complex distortion patterns can either be had or turned down with this control and since
the input can be made into a voltage input the unit can go after other pedals- of course then the interaction with guitar pick up and the low current impedance would be non present- actually what this means is that as a current input gain of circuit depends on what the source impedance is and if it is a guitar pick up then the
most gain will be had when impedance of pick up is at its lowest which is its DC resistance. As frequency rises so does impedance of pick up and thus at higher frequencies there’s less amplification. This can also be viewed as a series coil feeding into a low shunt impedance and that forms a lowpass filter.
When guitar volume is turned down output impedance of the guitar rises swiftly and is at worst case at 8 with a 500K Log pot 250K and thus gain of circuit is reduced drastically and total fuzz level drops even further as the volume control on guitar is turned down due to the voltage division.

As crude as it is then this circuit makes a lowpass filter at the input due to pick up loading and a lowpass filter at the output via the impedance the Volume control forms as source and the shunt being the capacitance in the following cable. For those inclined to compute worst case output impedance is 250K
and the typical capacitance in an (orange) spiral cable would at worst case be 2000pF. :coffeenews

I recall early reading on fuzz pedals and fuzz sounds back in the 70’s that the principal would be to lowpass filter before intense clipping and lowpass filter after. As can be seen the circuit does just that while in a somewhat uncontrolled and crude way. :violent1


Fuzz control and this sets the total gain of the circuit from something controlled to the maximum the chosen transistors can give at in this circuit hfe1 time hfe 2- only the current input restricts maximum gain when feed by a guitar as explained above.


This is a modern design though so it has standard polarity DC inlet and a pilot LED and it’s true bypass and is housed in a typical floor pedal format like Hammond 1590B.

Anyway more on how this circuit works as a pedal :study

Due to the choices made the Sparkle Face has fairly decent noise levels for being a fuzz of this type.

As a model for the sound I envisioned a new shipment of fuzz pedals to a hip guitar store in the 1960’s and the privileged ones being there before opening hours picking the raisins out of the cake- now what would the best one sound like and play like if I had that opportunity to pick my favourite before opening hours?

I’d like mine to be one that could sound even but also broken at will as in a sound you can control with your hands ( this is where the Saturation control comes in btw) and I’d like when volume control turned down to get a slightly distorted sound even to a shade I might rather use instead of a dead clean sound.
I’d also like to able to use the fuzz pedal after wha and if I could wish anywhere I could think of putting it. I’d also be content without tone controls if the sound is balanced. :music

More later have fun
BJ
User avatar
BJF
 
Posts: 522
Joined: Tue Feb 27, 2007 4:43 am
Location: Stockholm
Guitars:: Les Pauls, V with P-90's and humbuckers, strats,tele duo-jet and expanding; pick ups mostly Lundgren or BJF/ Lundgren
Danelectro Barython
amps: MP CS-40, MP101, Hiwatt Custom 200, Hiwatt Custom 100, VOX AC15
Fender Blues De Ville, Fender Super Reverb, Marshall 5150 through various speakers
pedals: 42

Re: >>> Sparkle Face Research Project <<<

Postby cajone5 » Mon Oct 03, 2016 8:58 am

I love fuzz. By far my favorite effect so I'm in (depending on cost of course). I typically build my own in this area (fuzz) but am really interested in seeing BJ's take on the fuzz face.

Thanks for keeping me in the loop.
Timing has a lot to do with the outcome of a rain dance.

BJFe: DIY CB, DIY FF 3.5%
User avatar
cajone5
 
Posts: 931
Joined: Wed May 19, 2010 9:44 am
Location: Austin, TX
Guitars:: 2006 Taylor 214e
2014 Fender Strat 60th Anniversary
Mainland Tenor Uke
amps: 5e3 Deluxe
'68 Custom Deluxe Reverb
pedals: 99

Re: >>> Sparkle Face Research Project <<<

Postby Crusty » Mon Oct 03, 2016 10:38 am

A 'Face blessed by Bjorn? This was worth firing up the old, dusty registration from a while back for!

Put me in, Coach ... I'm ready to play.
This might get loud.
User avatar
Crusty
 
Posts: 6
Joined: Mon Oct 03, 2016 10:26 am
Location: Riding a boxcar to Mars ...
Guitars:: Fender Esquire w/ Don Mare 3-speed
amps: Headstrong Lil' King
pedals: 0

Re: >>> Sparkle Face Research Project <<<

Postby BJF » Mon Oct 03, 2016 11:40 am

Hi there,

I might say I have never been that keen on this circuit to own a pedal like this while I do have McFuzz001 on my shelves. However I have repaired many old units. This time though I’d like to have one.
I have thought about getting more gear that behave as they did yesteryear and so I have gotten myself a stock TS-9 and a stock Super Reverb among things and so a Fuzz Face would be nice :whistle

With some help I can also see about making a DIY project out of this and then perhaps go a bit deeper in to theory and practical assembly.

So if I can get some volunteers a DIY can also fly along side. :wave :wave:

Meanwhile I’d be very interested in thoughts on Fuzz Faces what is good specifically… :drooling


Have fun and more to come
BJ
User avatar
BJF
 
Posts: 522
Joined: Tue Feb 27, 2007 4:43 am
Location: Stockholm
Guitars:: Les Pauls, V with P-90's and humbuckers, strats,tele duo-jet and expanding; pick ups mostly Lundgren or BJF/ Lundgren
Danelectro Barython
amps: MP CS-40, MP101, Hiwatt Custom 200, Hiwatt Custom 100, VOX AC15
Fender Blues De Ville, Fender Super Reverb, Marshall 5150 through various speakers
pedals: 42

Next

Return to BJFE Discussion

Who is online

Users browsing this forum: No registered users and 2 guests