Bjfes and buffers

[jdandry]

So I'm inserting a Buffer in my rig and figured I should put it after my drive pedals but wanted
to check if any of my Bjfe drives would benifit being after the buffer. Right now I run..
old Crybaby (non-TB)- dual box (tunermute/TB loop w/GE601)-SWAW-RRB-EGDM-FF3.5%-DRD-
(thinking of inserting the buffer here)- old Phase90 (non-TB)-some Delay (don't have one yet) --1960 Gibson GA-20T, all GeorgeLs.
I think this would be the best way to do it. right or would any of the BJFe drives preform better after the buffer? Thanks!!

[thesjkexperience]

I wanna know too! I have a this1smyne buffer after my SBEQ in the chain listed below.

[Donner]

the whole long cables and directional cables and buffers and too many buffers and not enough buffers is all VERY rig dependant ... its all about a build up of impedance and where that lands in relation to everything around it and what that does to your EQ and dynamic response .....


this is probably the place where the ' use your own ears' axiom fits best..... its alot of plus and minus until you get what you want ....

try it and if it sounds better - then it does .