BJFE / BearFoot fx Guitar Effects Community

I'm putting together a new gig board. I ordered a Pedaltrain board and Pedal Power2+. One issue I've been having is moving knobs
in the heat of the moment at a gig when I step on a pedal. The worst is with the EGDM because the volume control is so sensitive. So I am thinking about getting a loop strip thingy on this new board. Any suggestions or thoughts? I was looking at the Voodoo Labs Pedal Switcher. Lots of good features. Most truebypass switchers out there don't have enough space between footswitches but the Voodoo is good on that. Also the benefit of not having my signal going through a bunch of patch cables. I would run my 2 fuzzes before the switcher. Any thoughts?

yeah Ive got the big foot problem too but I have wanted to get one of those for a longg time..... Cusack has a new Pedal Board Tamer that looked interesting too.....

Checked out the Cusack, nice but too big for me and expensive!

jdandry wrote:Checked out the Cusack, nice but too big for me and expensive!

Hi! -I'm Idar, how are ya?

For the features offered, the Cusack is quite a good deal if you ask me, but it IS a lot of everything and I don't think they make other models. You should def. check out 'this1smyne'- he has some very good, affordable TBP strips that are built and customized to order. I haven't had any experiences with him, but he has a great reputation- I'm sure someone will pop their head and confirm this

Here's a link-o:

Populärmusik från Vittula

SH.. Oopsie, that was copypasta from my previous thread entry
Here goes:

http://www.this1smyne.com/product_list/custom/looper/

I use a loopmaster clean/ dirty switch,
to change from one delay to another-
loopmaster pedals are about the same size as a BJF pedal-
If it were a single pedal issue-
perhaps a single looper of some form might be a cheap and small solution-
but you might be thinking about all the volume knob on other pedals too.
Fully relate to the sensitivity of the EGDM volume knob.
It can go from ok to over the top real quick.

I have some Loopmaster stuff, nice but I find their strips have the switches too close together. I'll check out this1smine stuff.
Thanks!