BJFE / BearFoot fx Guitar Effects Community

Anyone know where I can get a cable which plugs into two outputs of a VL PP2 or Trex Fuel Tank Junior and therefore doubles the milliamps of the cable, but keeps the voltage at 9v instead of doubling it to 18v?

Trying to power a DD20 off a Trex Fuel Tank Junior- two outputs have enough milliamps but I need to not double the voltage. Where do I get one?

Go to the link below, scroll down to double amp power supply cables...

http://www.stompin-ground.com/products/sgcablepp2.htm

Double Amperage Y -type Extension Cable - 7" Long. Use to connect two output jacks into one and double the amperage. There is an in-line jack on the other end to connect (extend) any single Voodoo Lab type power cable. The 2 output voltages and DIP switch settings must be identical.

IMPORTANT NOTE: This cable has been requested often and is used but it is not openly recommended by Voodoo Lab. This is the only cable here not recommended by Voodoo Lab. Use at your own discretion.