I could do that. I wish I had a good way to get sound into my computer so I could do a few sound samples. But, even then, the thing with compressors is the feel as much, or more, than the tone.
I guess I have been lucky in all my past BJFE searches as I have never had to wait so long to get a reasonable offer for someone to sell a pedal.
Anyway, I did get my board back together, tried some new settings on my Swart, put the T-Bone in open G and
I know I am running the compressor is a very different way than most by using it at the end of dirt, but before Ruby Red Booster. Like Donner said, it can fill in a bit and at lower volumes act like an amp input and you adjust the sag by adding compression, or not. It takes some of the duty off of the OD and also allows easier stacking since volumes don't get too far out of control!
I will be in a bind if I love the PGC better than the FGC CB for compression as I would surely miss the sustain mode. So far running at 12 Volts works just fine at the end of dirt, but I wonder if I should then run the Ruby at 12 Volts also? But, I guess that is another thread