BJFE / BearFoot fx Guitar Effects Community

I made a mistake and ran it at 18v for a probably under a minute, twice. Didn't sound good. Seems to sound ok now, did I do any damage? How would I know? Is the only symptom after this, no sound at all or is there some degradation of the sound?

Thanks in advance!

yeah should only go up to about 15v I beleive..... how does it sound now ??

Thanks. Sounds pretty good, I'm doubting I did any damage. Did not sound good at 18v though. I'm guessing if was going t break, it would just fry a cap or something and not make any sound.

cool yeah its probably fine -- if it aint broke dont fix it ...

Donner wrote:cool yeah its probably fine -- if it aint broke dont fix it ...

I was going to use the exact same words before reading this!

wonderboy wrote:

Donner wrote:cool yeah its probably fine -- if it aint broke dont fix it ...

I was going to use the exact same words before reading this!

or yeah if aint broke keep fixing it until it is

Donner wrote:

wonderboy wrote:

Donner wrote:cool yeah its probably fine -- if it aint broke dont fix it ...

I was going to use the exact same words before reading this!

or yeah if aint broke keep fixing it until it is

If you can't fix it, I can fix it so noone else can fix it

Ok, you guys have freaked out. It's working, I'm going to break it. Maybe I should have it blueprinted.

Hi,

I believe you'd know if you actually broke it.

You know where my mailbox lives in case you need assistance.

At your service
BJ

don't break the honeybee........

she wants to FLY!