Bottom plate replacements?
Posted:
Tue Nov 18, 2008 2:54 pmby cardinal of crunk
I'm thinking it would be a good idea to replace the bottom plate on a few incoming BJF's so that I can put velcro on them and not have to worry about tearing up the nice paint job. I have a Phase 90... would that fit? If not, can anyone recommend where to look for one, or give me the model number of the enclosure/enclosure of the same size?
Re: Bottom plate replacements?
Posted:
Thu Nov 27, 2008 10:00 amby Eskimo_Joe
bump, anybody have the scoop on this?
Re: Bottom plate replacements?
Posted:
Thu Nov 27, 2008 3:50 pmby NewarkWilder
I picked up a couple of these for this very appilication--
http://cgi.ebay.com/NEW-SENSOR-1290NS-D ... 240%3A1318
it'd be nice to find super cheap bottom-only plates but these boxes are the right size and come with the bottom plate w/ just the right screws and holes and everything. you might find a better option out there but this is what I did. Cool seller, he's got some other painted boxes too.
Re: Bottom plate replacements?
Posted:
Mon Feb 02, 2009 3:58 amby bjfanimal
Hi.
My first post here. I think Björn use the ELFA K430 box.
http://www.elfa.se/ - search for ELFA K430 - there you have it.
Hope this helps